Rectangles and polygons aren’t special object types. to draw a line 123' long, with the bearing S12°34'56"E, use: @123 key @ = Sets the entry to relative so it treats your start point as 0,0 Distance = The distance you want the line to travel in the angle you are going to enter < = Indicates the next entry is an Angle AutoCAD displays the current command settings and prompts you for the offset distance — the distance from the original object to the copy you’re creating: Current settings: Erase source=No Layer= Source OFFSETGAPTYPE=0 Specify offset distance or [Through/Erase/Layer] : Type an offset distance and press Enter. if you want to learn "how to draw a line in autocad with coordinates" then you came to right place because here you will find "AutoCAD line command tutorial with exaple". Select your starting point 3.) If you are using Civil 3D then post on the Civil 3D forum as this would be created by a projected fill line. The AutoCAD window opens with an empty drawing file named Drawing1.dwg.. 2 Check the status bar to make sure you are in the 2D Drafting & Annotation workspace. After introducing the offset distance this message will be displayed: Select … I will select a line as an object and will give 700 mm length. I was drawing a lot of lines with the pointer that stuck at the end of the line and after that it stuck at the beginning of the other line (i hope you understand what i mean). Write directly from the keyboard the offset distance and press Enter or select from drawing two endpoints of an imaginary line whose length is the required offset distance. Alternatively, you can indicate an offset distance by picking two points on the screen. We can make many copies of the line at a particular distance in a short time by using the offset command in AutoCAD. To draw a line in AutoCAD you can use the command line length